Page 1 of 1
30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 4:53 pm
by Disco4
Hi Manne,
Ek laai my 30 06 met 165gr norma oryx punte maar my spoed lyk vir my baie laag.
Dis ‘n RSA aksie
1:10 twist
24duim loop
Norma doppe
CCI 200 primers
S365
TPL 82,8
55gr - GMS 2500vs
54,6gr - GMS 2516vs
55,8gr - GMS 2475vs
Baie dankie
Sent from my iPhone using Tapatalk
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 4:55 pm
by Disco4
//uploads.tapatalk-cdn.com/20190613/cb328bc880bdb587b1fe91188d64742e.jpg
Sent from my iPhone using Tapatalk
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 5:32 pm
by Dale SH
A good hot batch of S365 is marginal for a 165 grain bullet - some of the last batches produced are just downright unsuitable.
I have some Lot 71 and 81 which I use with a 168 grain TTSX and I still have to compress the load.
Use S355 or one of the imported equivalents.
I'm guessing you using Lot 89, 91 or 92
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 5:39 pm
by Disco4
Mine is lot 85
Sent from my iPhone using Tapatalk
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 5:39 pm
by Dale SH
One of the very slow batches !
Get S355 or an imported equivalent
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 5:40 pm
by Disco4
Thx will have a look
Sent from my iPhone using Tapatalk
Re: 30 06 lae spoed met 165gr
Posted: Thu Jun 13, 2019 5:44 pm
by Dale SH
Something like Norma URP or Vihta N550 will get you too node 5 at between 2700 and 2750 with a nice full case and pressure around 50 000 psi